Honeywell Vocollect, Справочник по аппаратуре

Страница: 236 / 316

| Chargers | 236
Item # Quantity Description
7 8 Screw, #8x1.5 Phillips pan head
8 2 Screw, #10-24x.312 hex, socket head
9 1 Drilling template sheet
You will need the following equipment:
• Drill with 1/8” bit
• Screw driver, #2 Phillips
• Allen key, Hex 1/8”
1.
Secure the rubber feet to the stand using the Phillips screws.
2. Position the stand so that its top lip is inserted into the center channel in the back of the charger.
3.
Secure each stand to the charger by inserting Phillips screws through the holes in the stand and screwing them into
the slot on the bottom of the charger.
4. Using the drilling template, mark the eight holes for the anchors. The bottom anchor holes must be at least 12
inches from the floor.
5.
Drill the pilot holes for the anchors, and install the battery charger with wall anchors or screws on 16” centers.
6. Place one of the extrusions against the wall and align its holes with the installed anchors. The extrusions have a
specific inside and outside edge and must be placed onto the wall correctly. The inside edge of the extrusion has
the T-channel into which the chargers are inserted.
7.
Insert a screw through a washer and the hole in the extrusion, then into the anchor. Tighten the screw to hold the
extrusion in place. Repeat this step with the other screws and washers.
8. Repeat the previous two steps for the other extrusion.
9.
Make sure that the extrusions are vertical and then secure them by tightening the screws all the way.
10. Locate the small hole in the bottom of the T-channel on the inside edge of each extrusion. Insert one of the socket
head screws (item 5) into both of the bottom holes and tighten them all the way.
Figure 168: Mounting the Extrusions
Connecting the Power Supply to the T1 10-Bay Charger
1. Connect the AC cord to the left end of the power supply that is mounted inside the charger.
2. Route the cable through the plastic clips as shown.