Honeywell Vocollect, Справочник по аппаратуре

Страница: 185 / 316

| Honeywell Wireless Headsets | 185
Headset Functions and LED Patterns for SRX2
Figure 133: SRX2 User Interface
Headset Function User Action Headset Mode LED Pattern Tone
Power on Press Power button
for half a second
Headset powers up
in low power pairing
mode
Solid green High pitch double
beep
Power off Hold Power button
for one second
Headset powers off Solid green, then off
Important:
Do not
remove the
battery until
the LED is
off.
Low pitch double
beep
Increase volume Press the Plus (+)
button
N/A N/A Two tone ascending
sequence. If
connected, device
says, "louder."
Decrease volume Press the Minus (-)
button
N/A N/A Two tone descending
sequence. If
connected, device
says, "softer."
Force disconnect for
manual pairing in
low power mode
With headset
connected, press the
Plus (+) and Minus
(-) buttons
Headset disconnects
current pairing and
enters low power
pairing mode
Solid green No tone when
entering mode. Three
ascending tones upon
pairing with a device
Switch to high power
pairing when pairing
in low power mode
has failed
With headset in
pairing mode, press
the Plus (+) and
Minus (-) buttons
Headset enters high
power pairing mode
Note: This
mode is
recommended
only if
low power
pairing fails.
Rapid flash, then
solid green
No tone when
entering mode. Three
ascending tones upon
pairing with a device