THX9321 PRESTIGE
®
2.0 AND THX9421 PRESTIGE
®
IAQ WITH EIM
68-0311—02
20
3.
Type the sensor name and press Done. The sensor
names are used when selecting which sensor to use for
temperature, humidification, and dehumidification con-
trol.
Fig. 51.
NOTE: If you link more than 1 wireless indoor sensor,
and forget to name them, you will be prompted
to name each wireless indoor sensor after you
exit wireless setup. See Fig. 52.
Fig. 52.
Linking Entry/Exit Remote or Vent Boost
Remote
1.
Press and quickly release the CONNECT button.
Fig. 53. Connect button and status light on Entry/Exit
Remote or Vent Boost Remote.
2.
After a short delay, the status light will glow green for 15
seconds. If the status light turns red, the remote did not
link with the thermostat for the connection process.
NOTE: The thermostat can work with up to 3 Entry/Exit
remotes. Each Entry/Exit remote can control up to
16 thermostats.
NOTE: The thermostat can work with up to 6 Vent Boost
remotes.
Finding Your Password (Date Code)
to Access Installer Options
You will need the thermostat password to:
• Make changes to the Installer Setup.
• Setup Diagnostics.
• Perform an Installer Test.
• View Data Logs.
• Add, remove, rename or view connected RedLINK
accessories.
• Reset the thermostat to Factory Default settings.
The password (Date Code) is located on the back of the
thermostat.
Fig. 54. Finding thermostat password.
The password (Date Code) can also be found by following
these steps:
1.
Touch Menu.
2.
Select Dealer Information.
Fig. 55. Finding thermostat password.
1324
1324
Password
(Date Code)
Dealer Informaon
OK
