Honeywell Thor VM3, Руководство пользователя, Страница: 237 / 378

Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide 225
5. Tap Configure.
6. Configure the baud rate and other parameters as desired.
Note: The default baud rate is 19200. The higher the baud rate chosen, the less reliable the
connection tends to be.
7. Tap OK to close and save the Device Properties window,
8. Tap TCP/IP Settings.
9. All settings should be checked except Use Slip.
10. Tap OK to close TCP/IP Settings window.
11. Tap Security Settings.
12. Make sure Use data Encryption, Use Extensible Authentication Protocol (EAP) and
Preview user name and password are unchecked. All other options should be
checked.
13. Close OK to close all open panels.
Configure PC Connection Settings
1. Select Start > Settings > Control Panel > PC Connection.
2. Check Allow connection with desktop computer when device is attached.
3. Verify that pane says Connect using ‘ActiveSync’. If necessary, tap the Change
button to select the correct setting.
Note: Do not use USB as this option is not supported on the Thor VM3.
4. Click OK to confirm settings and close the open window.
Setup PC or Laptop
The PC or laptop must have a Windows operating system.
1. Verify Windows Mobile Device Center (WMDC) is installed if the PC or laptop is run-
ning a Windows 7 or greater operating system. For a PC or laptop with a Windows XP
operating system, ActiveSync must be installed.
Note: WMDC can be downloaded from microsoft.com.
2. Open WMDC and select Mobile Device Settings > Connection Settings.
3. Make sure Allow connections to one of the following is checked.
4. Select the COM port to which the full-wired null-modem cable is attached.
5. Check the option Allow automatic device authentication.
6. Check the option Allow data connections on the device when connected to the PC.
7. Click OK to save the settings and close the open window.