Honeywell Thor VM2, Руководство пользователя, Страница: 138 / 398

126 Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Disconnect UPS Battery
Equipment Required
The following equipment is user-supplied:
• Torquing tool capable of measuring inch pounds
• #2 Phillips screwdriver bit
Disconnect Procedure
1. For convenience, the Thor VM2 can
be removed from the dock, though
it is not necessary.
2. If the Thor VM2 remains in the
dock, disconnect the power cable
from the dock.
3. Place the Thor VM2 in Suspend by
pressing the Power button.
4. Place the Thor VM2 face down on a
stable surface.
5. Using a #2 Phillips bit loosen the
M3 screws and then remove the
tethered access panel with the SIM
label. This panel is on the right hand side when the Thor VM2 is face down with the
top away from the user.
6. Locate the small push button located just below the SIM card
installation slot.
7. Press the push button to disconnect the UPS. The UPS battery
maintains its charge but is disconnected from the power circuitry of
the Thor VM2.
8. Reattach the access panel, torquing the M3 screws to 4-5 inch pounds
using a #2 Phillips bit.
9. When the Thor VM2 is attached to external power, the UPS battery is
automatically reconnected.
10. Restart the Thor VM2.
Caution: The UPS battery must be disconnected before you ship the Thor
VM2 or Replace Front Panel .