Honeywell SmartPAC 2, Руководство пользователя, Страница: 218 / 522

1126800 SmartPAC 2 with WPC Integration
Page 196 Chapter 3 SmartPAC 2 Keyboard, Displays
and Operating Modes
that you programmed for a sensor and/or cam channel. The cursor keys graphically move a
circular arc around this diagram. These cursor keys function in this way only when you have
selected a display to make or change timing settings. See Chapter 5 for complete instructions
on how to create a tool number and make all settings.
••••
RIGHT cursor key ( ) increases the "ON" setting – moves the ON end of the arc
clockwise.
•
LEFT cursor key ( ) decreases the "ON" setting – moves the ON end of the arc
counter-clockwise.
•
UP cursor key ( ) increases the "OFF" setting – moves the OFF end of the arc
clockwise.
•
UP cursor key ( ) decreases the "OFF" setting – moves the OFF end of the arc
counter-clockwise.
Go to the next page and follow the instructions for setting timing.
NOTICE
See page 307 for information on programming multiple ON/OFF arcs.
1. The following illustration shows the starting point for setting cam ON/OFF timing. The
box inside the circle diagram shows ON at 0
°
, OFF at 0
°
and “dwell” (the number of
degrees the channel is ON) is 0
°
.
Figure 3 - 24. Setting Cam Timing