Honeywell SmartLine, Руководство пользователя

Страница: 72 / 130

6. Operation
6.3. Transmitter PV display
58 SmartLine Wireless User's Manual Revision 2
Table 6-6: Device status
Transmitter display OneWireless User
Interface display Definition What to do
OoS OOS All channels are out of
service. Restore mode to Auto in
OneWireless User Interface.
SNSR ERR Sensor Error Sensor can not access
meter body A/D
converter. Check connection between
sensor module and meter
body. If still doesn't work,
replace sensor. See page
70 .
OVR TEMP Over Temperature The meter body has
exceeded the
maximum temperature
as defined by the meter
body characterization
data. Determine cause excessive
temperature.
OVR LOAD Over Load The applied pressure
has exceeded the limit
defined by the meter
body characterization
data. Determine cause of over
pressure.
‘U’ Status
Calibration Error Calibration Data Invalid
or could not be read. Use Cal Clear, or User
Calibrate.
LOW BAT Low Battery Battery Voltage
Critically Low Replace batteries as soon as
possible. See page
71 .
NO RADIO Radio Interprocessor
Comm Error Radio Board is not
accessible. Restart both the radio and
sensor. If condition persists,
replace sensor module. See
page
70 .
The following status messages have multiple meanings. Refer to OneWireless UI Device Status for exact cause.
‘F’ Status
Input Failure Input Error Possible meter body sensor
failure.
‘F’ Status
NVM Fault* Startup diagnostics
detected defect in
Sensor Non-Volatile
Memory Replace sensor module. See
page
70 .
‘F’ Status
Program Memory
Fault* Startup diagnostics
detected defect in
Sensor Read Only
Memory Replace sensor module. See
page
70.
‘F’ Status
RAM Fault* Startup diagnostics
detected defect in
Processor Random
Access Memory Replace sensor module. See
page
70 .
The following statuses are displayed only in OneWireless UI Device Status.