Honeywell SmartLine, Руководство пользователя

Страница: 61 / 130

4. Start up
4.6. Calibrating the transmitter
Revision 2 SmartLine Wireles User's Manual 47
Procedure for field calibration of Honeywell compound characterized SmartLine Wireless
Transmitters
This procedure applies to the following Honeywell SmartLine Wireless Transmitters

0-25 to 0-400 inH
2
0/0-62.2 to 0-1000 mbar Compound Characterized

0-5 to 0-100 psi/0-0.34 to 0-7 bar Compound Characterized
Honeywell SmartLine Wireless Transmitters are fully characterized at the factory and have an
applied factory calibration over the range of the transmitter (URL). Field calibration is provided
to allow up to 5% adjustment over a reduced operating range providing accuracy within .075% of
the reduce range or ±0.025 + 0.05 20 psi span psi or ±0.025 + 0.05 (1.4 bar) span bar in % span.
Compound characterized pressure transmitters allow calibration at both positive and negative
relative pressure calibration points within the characterized range of the transmitters meter body.
Table 4-2: Field calibration
SmartLine
Wireless
Model Description Range Limits Span Limits Min Lower
Range
STFW128
Flange Mounted Liquid Level
Transmitter 0 to 4.0 inH
2
O 0 to 400 inH
2
O -400 inH
2
O
STFW132 Flange Mounted Liquid Level
Transmitter 0 to 1.0 psi 0 to 100 psig -100 psi
STFW924 Flange Mounted Liquid Level
Transmitter 0 to 10 inH
2
O 0 to 400 inH
2
O -400 inH
2
O
STFW932 Flange Mounted Liquid Level
Transmitter 0 to 5 psi 0 to 100 psig -100 psi
STRW12D
Remote Diaphragm Seal Pressure
Transmitter 0 to 4.0 inH
2
O 0 to 400 inH
2
O -400 inH
2
O
STRW13D Remote Diaphragm Seal Pressure
Transmitter 0 to 1.0 psi 0 to 100 psi -100 psi
STRW93D Remote Diaphragm Seal Pressure
Transmitter 0 to 5.0 psi 0 to 100 psig -100 psi
Upper and Lower Calibration:
The SmartLine Wireless Transmitters provide calibration for upper and lower calibration points
as well as the option for calibration of zero. The zero calibration is independent of the upper and
lower calibration and is applied as a bias whereas upper and lower calibration adjusts the gain
and offset of the characterization. Zero calibration is available from the local interface at the
transmitter and is done with the device mounted in its operating orientation and applied “zero”
offset head pressure.
Upper and lower calibration are only available when connected to the network where access to
the upper and lower calibration points as well as access to the calibration command is available.
Upper and lower calibration requires the values for the upper and lower calibration points to be
entered and the status of the calibration operation to be verified.