Revision 2
SmartLine Wireless User's Manual
103
B4. Radio Compliance Information
The SmartLine Wireless pressure transmitter uses a low powered ISA100 2.4GHz radio to
communicate with the Radio Infrastructure and Gateway devices that are connected to a wired
DCS network. The wireless transmit power is set at the factory depending on the destination
country. The combination of allowed transmit power and antenna gains result in a maximum
EIRP of 26 dBm = 398 mW transmitted power. This power is limited depending on destination
country.
Table B4: Radio Certifications
Agency
Certification
Description
Federal Communications
Commission (FCC)
FCC ID:
S5751454941
The SmartLine Wireless Transmitters comply with part 15 of the
FCC rules. Operation is subject to the following two conditions.
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Industry Canada (IC)
IC:
573I-51454941
The installer of this radio equipment must ensure that the
antenna is located or pointed such that it does not emit RF fields
in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada’s web
site
www.hc-sc.gc.ca/rpb.
The SmarLine wireless transmitter has been assessed and is in
compliance with the Radio Equipment Directive (RED)
2014/53/EU.
Radio Frequency (RF) statement
To comply with FCC’s and Industry Canada’s RF exposure requirements, the following antenna
installation and device operating configurations must be satisfied.
Remote Point-to-Multi-Point antenna(s) for this unit must be fixed and mounted on outdoor
permanent structures with a separation distance between the antenna(s) of greater than 20cm
and a separation distance of at least 20cm from all persons.
Remote Fixed Point–to-Point antenna(s) for this unit must be fixed and mounted on outdoor
permanent structures with a separation distance between the antenna(s) of greater than 20cm
and a separation distance of at least 100cm from all persons.
Furthermore, when using integral antenna(s) the SmartLine Wireless Transmitter unit must
not be co-located with any other antenna or transmitter device and have a separation distance
of at least 20cm from all persons.
European Union restriction
The SmartLine Wireless Transmitters are in conformity with the applicable standards as required
by the Radio Equipment Directive (RED) 2014/53/EU.
Restriction
France restricts outdoor use to 10mW (10dBm) EIRP in the frequency range of 2,454-2,483.5
MHz. Installations in France must limit EIRP to 10dBm, for operating modes utilizing
frequencies in the range of 2,454 – 2,483.5MHz.
Содержание SmartLine
