Honeywell Rapid Eye, Руководство администратора

Страница: 191 / 294

Rapid Eye Multi-Media DVR System Administrator Guide
Document 800-02953V4 Rev A 191
03/10
Replacing a Unit
New Unit
When you replace a Multi-Media unit at a site with a new unit from the factory, the factory
unit’s
last valid password
(LVP) is blank.
Use LVP Utility to Match Site Definition
If you replace a Multi-Media unit and your Multi database is set to a system password (see
System Password , page 184 ), you need to use the LVP utility to match the site definition to
the blank password on the unit.
Figure 10-5 Use the LVP Utility when a Unit Replaces Another
Replacing a Unit when a System Password Is Enabled
TIP! This unit replacement procedure only applies when you replace a unit at a site that
has already been defined and is operational.
The procedure does not apply to adding a new site to your Multi system. To simply add a
site to your system, see
Adding a Site on page 35 .
1. Check that the Multi-Media unit is powered-up at the site.
2. Using Admin, update the site’s definition (see Updating a Site on page 37 ).
3. Click LVP (last valid password). A Reset Last Valid System Password dialog box
appears. Note the asterisks in the unit Password and Confirm Password fields.
Use the LVP utility to replace
a unit at a secured site. Use
the utility to delete the
asterisks (*) that represent
the system password used at
that site.