Honeywell PM23c, Руководство пользователя, Страница: 48 / 164

Chapter 2 – Set Up the Printer
38 PM23c, PM43, and PM43c Mid-Range Printer User Manual
Print a Test Label with the Icon Printer
When you turn on the icon printer, all of the LEDs on the display light up
including the Ready-to-Work indicator. One by one, the LEDs turn off as
the printer starts up. The first LED to turn off is the Ready-to-Work
indicator. The LEDs then turn off following a sequence from the top left
LED to the bottom right LED.
1 Connect the printer to power and turn on the printer.
2 The printer goes through its startup sequence and all of the LEDs light
up. When the last two LEDs are lit (Printhead Hot and Maintenance),
press and hold the
Print button until the test label starts to print.
3 Release the Print button.
The series of three test labels prints out.
Print a Test Label with the Full Touch Printer
The first time you turn on the full touch printer or reset to factory defaults,
the printer runs a startup wizard to let you enter basic setup information.
After the startup wizard finishes, the printer enters Ready mode where
you can choose to access the Main Menu and print a test label.
1 Connect the printer to power and turn on the printer.
2 After the startup sequence finishes, the startup wizard begins. After
you enter all of the information on the wizard screens, click
No when
prompted to run other wizards.
3 From the Ready screen, tap the Main Menu button on the status bar.
4 From the Main Menu, tap Tools > Test Labels .
5 Select the test label you want to print and tap it.
Your test label prints. If print quality is low, go to Wizards > Printing
> Print Quality .
Calibrate the Screen
If you are having problems with the full touch screen responding when
you tap it, you may need to calibrate the screen.
1 On the keypad, press ./- to enter the Main Menu.
2 Press 2 until the Wizard button is selected and then press Enter .
3 Press 2 until Calibration is selected and then press Enter .