Honeywell PM23c, Руководство пользователя, Страница: 37 / 164

Chapter 2 – Set Up the Printer
PM23c, PM43, and PM43c Mid-Range Printer User Manual 27
4 Route the media through the print mechanism.
5 Adjust the printhead balance. For help, see Chapter 6.
6 Adjust the label gap and black mark sensor. The sensor LED should
line up with the center of the media. For help, see Chapter 6.
7 Turn the printhead lift lever clockwise to close the printhead. The
printer performs the action defined by the Head Down Action setting.
8 Press the Print button to advance the media.
9 Close the media cover.
10 Configure the printer for the correct media type (media with gaps,
black mark, continuous fixed length, or continuous variable length).
11 Calibrate the sensors on the printer. You can calibrate the media from
the Main Menu (
Wizards > Calibration > Media ) on a full touch
printer or from the web page ( Services > Media Calibration ) for all
models of the printer.
12 Configure the start and stop adjust settings.
About the Label Dispenser
The label dispenser accessory, which includes the Label Taken Sensor,
removes the liner from self-adhesive label stock as each label is printed.
You manually remove the label at the front of the printer.
After you load media, you need to configure the feed adjust settings. You
may need to adjust the recommended values slightly depending on your
media type, supply method, and roll sizes, or because of individual
differences between printers.
Load Media for the Label Dispenser
If you have the optional label dispenser installed in your printer, the printer
will separate self-adhesive labels from the liner. The label taken sensor
causes the printer to wait for you to remove a label before printing the next
one. You can also install the internal media rewinder if you want to rewind
the liner.