Honeywell MS2421, Инструкция по установке и эксплуатации

Страница: 37 / 72

Wake Activation Area (Photocell LED Output)
The MS2421/MS2422/MS2431 scanner’s default power save mode
†
is Dual Action Power Save Mode #2 (see
page 41). This power save mode turns the laser OFF after a configured period of non-use then turns the motor
OFF after thirty-minute intervals. Any movement detected by the photocell in the activation area, shown below
in grey, will cause the scanner to exit the power save mode. The motor will restart automatically and the laser
will turn back on preparing the scanner for bar code recognition, decoding, and transmission.
Figure 31. Wake Activation Area Perpendicular to Package Flow Default Range
(Photocell LED Output)
†
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power
save modes.
Specifications are subject to change without notice.
33