Honeywell Midas-M, Руководство пользователя

Страница: 29 / 109

CHAPTER
3
Device & Web Operations
Learn what you can do with your Honeywell Midas®-M Detector, from commissioning to
Maintenance
Comissioning
Comissioning should be followed carefully and only performed by suitably trained personnel.
WARNING
Before carrying out any work, ensure local and site procedures are followed. Ensure that
the associated control panel is inhibited to prevent false alarms.
1. Ensure the detector is wired correctly.
2. Ensure that the correct sensor cartridge is fitted. (If the cartridge has not been stored at room
temperature, allow one hour for equilibration.)
3. Ensure the ON/OFF switch on the bottom of the mounting bracket assembly is in the ON
position.
4. Apply power to the system. Wait for a couple of minutes until the start-up routine completes.
5. After the start-up routine, the detector will display the Normal/Monitoring Operating Mode.
6. Perform a leak test to ensure all connections are secure. ‘
Waiting…
’ will be displayed on booting
time.
7. Allow the detector to stabilize until the ‘
Warm-up
’ message is no longer displayed after booting.
The maximum warm-up time is dependent on sensor type. Refer to individual cartridge data
sheets. Warm-up times are typically much faster.
8. Ensure the correct ID code is selected in Set-up > alarm menu
9. If this is a first-time start-up, the “
Detect New Cartridge ~
” message could be displayed. Press
the ‘O’ button to clear the message.
Midas-M 29 User Manual