Honeywell INTEVIO, Руководство пользователя

Страница: 17 / 133

9
No. Parts/Ports Description
14 System interface
Interfaces will be connected to third party systems:

ALARM - A dry contact output to transmit the voice
alarm status to third party system.

FAULT
– A dry contact output to transmit the general
fault status to third party system.

FIRE
– Used to connect to the fire alarm system via
the RS-485 bus.

CTRL- This port is reserved to connect to the third-
party system.

DEBUG 1/DEBUG 2 are reserved.
15 Loudspeaker interface
Speaker line interface of 8 zones, each zone has two speaker
lines (A&B).
16 Ethernet interface 10M/100M Ethernet interface.
17 USB interface To insert the USB storage.
18 CH1A OUT
The 100V output of the internal power amplifier corresponding
to the CH1A.
19
70V/100V interface of
external power amplifier Including the CH1B IN, CH2A IN, CH2B IN and the IN/OUT of
spare amplifier.
20 MODE
It is the DIP switch to set the work mode of current device and
system.
21 Calibration key It is reserved and unavailable.
22 DC power output 24V DC power output.
23
System extension
interface
To connect to optional zone expanders.
24 Fan Temperature controlled cooling fan
25 Backup power input To connect to 24V DC backup power supply.
26 Grounding screw To connect to grounding wire.
Technical Specification
Parameters Values
Main power supply AC 100-240 V, 50/60 Hz
Backup power supply 21.5 V DC - 28.5 V DC
Fuse T10AH 250 V
Power consumption <740 W
PTT Microphone
Sensitivity -59±3 dBV
Frequency response 100 Hz -14 KHz, ±3dB
SNR

50 dB, A-weighted
Auxiliary input
Number 2
Input sensitivity 1 V(0 dBV)
Input impedance
10 KΩ
Frequency response 85 Hz-18 KHz, ±3dB