Honeywell HX3, Руководство пользователя, Страница: 207 / 230

11 - 9
Inserting and Removing a Tethered Battery
Prerequisites:
• The AC adapter has been assembled and attached to the desktop cradle. Batteries can not charge in an unpowered desktop
cradle.
• The HX3 tethered battery has been removed from the armband or hip-flip battery sleeve or battery bracket.
Do not drop or slam the HX3 battery into the charging pocket. Damage may result.
A fully depleted Standard battery recharges fully in approximately four hours in a powered cradle charging pocket.
A fully depleted Extended battery recharges fully in approximately eight hours in a powered cradle charging pocket.
The HX3 tether connector must be at the top of the battery in the charging bay. The battery will not fit properly into the charging
pocket if the tether connector is inserted into the depression of the charging bay.
Each charging pocket can recharge either battery – standard or extended. The extended battery is noticeably thicker than the
standard battery.
Make sure the battery terminals line up with the charging terminals in the charging bay.
Inserting a Tethered Battery into the Charging Bay
Grasp the battery, not the tether, and ensure the battery terminals line up with the charger terminals in the charging pocket.
Slide the battery straight down into the charging pocket until the charging terminals meet.
The charging pocket LED illuminates.
See Indicators (page 11-6) to determine the status of the B1 or B2 charging pocket LED.
Removing a Tethered Battery from the Charging Bay
Grasp the battery, not the tether, and pull the battery straight up and out of the charging pocket.
The charging pocket LED (B1 or B2) turns off.