Honeywell HWF2A-COM, Инструкция по установке и настройке

Страница: 17 / 28

15
System Status Displays
[S]
ECP Flt
OK
ECP Mode
Displays system fault status.
• Flt : Represents radio faults
•
OK : Normal, No fault
o I : No network connectivity over IP and fault time has
expired
o i : No network connectivity over IP and fault time has
NOT
yet expired.
o
G : No network connectivity over Cell and fault time has
expired.
o
g : No network connectivity over Cell and fault time has
NOT yet expired.
NOTE : The 7720P will not operate if the power line voltage is
removed.
[T]
Test Msg Sent
Test
Alarm
Sends a Test alarm to AlarmNet. Functional for a
registered
communicator only. If the device is not registered, a message
is displayed indicating that the command cannot be executed.
[X]
Reset CPU Y/N
Reset the
Communicator
.
Pressing [N] returns to diagnostic mode (blank screen = enter
next command or escape).
Pressing [Y] resets the communicator (blank screen = reset
complete).
[ ↑ ]
(UP arrow)
Registering …
Registration
Registers a programmed communicator with AlarmNet.
[ ↓ ]
(DN arrow)
Enter PIN#
Registration
with PIN for Replacement Communicator
Registers a replacement communicator with AlarmNet, once
programmed, using the existing PIN #.
[0]
Force Server Update?
Y/N
Force Upload of Configuration File to Server
Pressing [Y] will force the device to upload its entire configura-
tion file to the server.
Pressing [N] cancels the operation.
NOTE: If the internet is not available, and the communicator is
not initialized when you enter this command, the following
screen will be displayed:
Cannot Upload
Try Later! _
Wait for the
signal quality
LEDs to light, indicating the commu-
nicator has completed its initialization, and try again.
[ENTER]
Strt Prog Mode?
Y/N_
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].