background image

     COLOR VANDAL PROOF CAMERA

    HVD-735NT/PT 
    HVD-735NW/PW
    HVD-505N/P

       About this manaul

      Dimensions : mm

   INSTRUCTION MANUAL

Before installing and using the camera, please read this manual
carefully. Be sure to keep it handy for later reference.
This instruction manual covers for use in the following models. Any
difference among the those models is indicated when necessary.

TROUBLESHOOTING

Before sending the camera out for repair, check the items
below. If the problem persists  after checking these items,
contact your service center.

 If no image appears

     Is the coaxial cable attached securely?
     Are the power and voltage normal?
     Has the iris of the lens inside the camera been
     adjusted correctly (with the level volume) ?
     Is there adequate illumination?

 If the image is unclear

     Is the lens in focus?
     Is the lens dirty?
     Dirt of fingerprints on the lens can adversely affect the
     images. Gently wipe any dirt or fingerprints off the lens
     with a soft cloth or lens cleaning paper and cleaning
     fluid (commercially available).
     Is the monitor adjusted correctly?

WARNING:
TO PREVENT THE RIST OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.

SPECIFICATION

 Do not open or modify

    Do not open the cabinet exet during maintenance and
    installation, as it may be dangerous and cause damages.

 Do not put objects inside the unit

    Make sure that no metal objects or flammable substances
    get insdie the camera. It could cause fire, short-circuits or
    damages.

 Be careful when handling the unit

    To prevent damage, do not drop the camera or subject
    it to strong shock or vibration.

 Install away from electric or magnetic fields

 Protect from humidity and dust

 Protech from high temperature

    Be careful when installing colose to the ceiling , in a
kitchen
    or boiler room, as the temperature may raise to high
levels.

 Cleaning

    Dirt can be removed from the cabinet only by wiping it
    with a soft cloth moistened with a soft detergent solution.

 Mounting Surface

    The mounting surface material must be strong enough
    to secure the camera.

Honeyw

ell

DC12V or AC24V

PRECAUTIONS

Содержание HVD-735NT

Страница 1: ...h a soft cloth or lens cleaning paper and cleaning fluid commercially available Is the monitor adjusted correctly WARNING TO PREVENT THE RIST OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE SPECIFICATION Do not open or modify Do not open the cabinet exet during maintenance and installation as it may be dangerous and cause damages Do not put objects inside the unit Make s...

Страница 2: ...essary to change settings Compensating for backlight 2 Setting gain control AGC 4 HVD 735NT PT ON When back light is so bright For adjusting the sensitivity of the camera Use this setting for shooting OFF Normal setting in dark environments CAUTION It will be correctly set by adjusting level volume 7 ON Normal setting OFF Set this when there is excessive noise CAUTION Check for polarity when using...

Страница 3: ...eter 73mm in the ceiling for routing the cables 6 Pass the power cable E and video cable F from the camera unit through the cable hole in the ceiling 7 Align the four screw holes in the camera unit C with the screw holes in the ceiling and then secure the camera in place by tightening the four or more screws G throught the washers 8 Carry out the settings and adjustments for the camera 9 If the do...

Страница 4: ...adaptor sync setting is set to internal sync If MANUAL WHITE BALANCE is set sync adjustment cannot be performed Change to a different white balance setting Adjusting level volume 7 If the entire image is too dark or bright or the backlight compensation is not correct even after 2 is set to ON you need to adjust the level volume CCW Low Closes the lens iris making the entire image darker CW High Op...

Отзывы: