Honeywell HRXD16, Руководство пользователя

Страница: 80 / 156

Configuration
80
Note You can set up motion zones one block at a time in groups of 8
or 16 individual block groups (9- and 16-channel DVR
respectively). A block group is positioned within the image area
using the Up and Down arrow buttons, and individual blocks
within the block groups are selected or cleared using the camera
buttons.
7. Press to display the menu screen. The menu on the setup screen has the
following functions:
Figure 3-63 Motion Detection Zone Menu
• Select — Activates highlighted blocks to detect motion.
• Clear — Deactivates highlighted blocks so that they will not detect motion.
• Reverse — Activates inactive highlighted blocks and deactivates active
highlighted blocks.
• Select All — Activates all blocks to detect motion.
• Clear All — Deactivates all blocks so that they will not detect motion.
• Reverse All — Activates inactive blocks and deactivates active blocks.
• OK — Accepts changes and closes Zone setup.
• Cancel — Exits Zone setup without saving changes.
8. You can control excessive event logging and remote notification of motions
detected after the motion dwell time by adjusting the motion ignoring dwell
intervals. Highlight the box beside
Motion Ignoring Interval and press . A list
of intervals ranging from 1 to 10 seconds or Never appears. The DVR will not log
and notify motion events occurred during the preset interval range.
Note The record action for motion events will not be affected by the
Motion Ignoring function.
9. Highlighting the box beside Daytime Setup and pressing allows you to set up
the Daytime range.
Figure 3-64 Daytime Setup Screen