Honeywell HRSD16, Руководство пользователя

Страница: 87 / 176

Configuration
Document 800-03650 Rev D 87
02/09
Watching How the DVR Reacts to Motion
Turn Zone View On in the Motion Detection Settings screen to observe how the DVR
reacts to motion. When in the motion viewing mode, any detected motion within the
zone displays in red.
Adjusting the Motion Ignoring Interval
You can control excessive event logging and remote notification of motions detected
after the motion dwell time by adjusting the motion ignoring intervals.
1. Highlight the field beside Motion Ignoring Interval in the Motion Detection
Settings screen and press
. A list of intervals ranging from 1 to 10 seconds to
Never appears.
2. Select a Motion Ignoring Interval from the list.
Now the DVR will not log and notify motion events that occurred during the preset
interval range.
Setting Up Sensitivity Levels for the Daytime Range
1. Highlight the Daytime Setup field in the Motion Detection Settings screen and
press
to set up the Daytime range. The Daytime Setup Screen appears.
Figure 3-60 Daytime Setup Screen
2. Highlight the field beside Daytime and press .
3. Use the UP and DOWN arrows to set the Daytime range.
The DVR considers the remaining time range as the Nighttime.
Motion Detection Actions Tabs
Using the Actions 1 and Actions 2 tabs, you can set the DVR to react to motion detection
differently for each camera. Each camera can:
• Be associated with another camera
• Trigger an Alarm-Out connector
• Sound the internal buzzer of the DVR
• Notify a number of different devices
• Move PTZ cameras to preset positions
• And/or display a camera on a SPOT monitor