Honeywell HRDVS, Справочное руководство

Страница: 28 / 140

Rev 2.00 12 Document 900.0281
02/07
Installation
P
Performing an Initial System Check
When you first install the HRDVS, we recommend that you perform an initial system check
as follows.
Turning the HRDVS On the First Time
1. Unpack the HRDVS and place it on a flat surface.
2. Attach the AC power cord to the HRDVS rear panel (see Figure 3-2 ) and plug the
other end into an 110 VAC/60 Hz or 230VAC /50 Hz receptacle. The power supply is
auto-switching; there is no need to configure it for your power setting.
3. Observe the LED display on the HRDVS front panel. The POWER button illuminates,
indicating the HRDVS has power applied to it. After the bootup process, the video
image appears on the monitor.
Rebooting (Restarting) the HRDVS
There is no on/off switch on the HRDVS. To restart it, disconnect the power cable from the
HRDVS or from the wall socket. Allow 30 seconds to pass, then re-insert the power cable.
After approximately 90 seconds, if recording is enabled the RECORD button on the front
panel of the HRDVS illuminates, indicating that the unit is recording.
Attaching a Monitor
1. Plug your monitor into an AC receptacle.
2. Connect a BNC cable to the Video In jack on the monitor. Connect the other end of
the BNC cable to the Video out jack on the HRDVS rear panel (see
Figure 3-2 ).
3. Turn on your monitor.
4. Press the MENU button on the front panel. The monitor displays a login screen.
You are now ready to fully install your HRDVS.
Attaching a Camera
1. Unpack a Honeywell camera and place it on a flat surface.
2. Connect power as required to the camera. Refer to the documentation that came with
the camera.
3. Connect one end of a BNC cable to the Video jack on the camera. Connect the other
end of the BNC cable to the Video In 1 jack on the HRDVS rear panel (see
Figure 3-2 ).