Document 800-20476V1 – Rev A – 05/2015
HD3UH(X) Ultra WDR Indoor Minidome Camera Quick Installation Guide
1
This document describes how to install the HD3UH(X) minidome camera.
The camera can be installed to a wall or ceiling using one of the following methods:
•
surface mount
•
flush (in-ceiling) mount
•
pendant mount
Important Safety Instructions
•
Read and keep these instructions.
•
Please ensure that your installation area can safely support the weight of the camera.
•
Do not install the camera in extreme temperature conditions. Only use the camera where
temperatures are within the limits shown in the specifications section of the user guide.
Be especially careful to provide ventilation when operating under high temperatures.
•
Do not aim the camera towards an extreme light source to prevent damaging the CCD.
•
This camera is rated for indoor operation; do not expose this camera to rain or moisture.
•
Do not touch the camera lens, dome or bezel (front glass plate).
•
Do not drop the camera or subject it to physical shock.
•
Do not use a strong or abrasive detergent when cleaning the camera.
WARNING
Installation and servicing should be performed only
by qualified and experienced technicians to conform to all local
codes and to maintain your warranty.
WARNING
This device is configured for 12 V DC or 24 V AC
operation. Do not connect to a higher voltage. Use only with NRTL-
approved Class 2 power supplies.
Package Contents
Before you begin, check that you have the following items:
Camera Overview
Installing the Camera
Disassembling the Camera
1.
Insert a coin into the notch on the camera base
and twist. Set the dome cover aside.
2.
Grasp the gimbal base with one hand and the base
skirt with the other and twist the gimbal base
clockwise to remove it from the skirt.
3.
Remove the main camera assembly from the base skirt.
Connecting the Cables
Connect the power and video cables.
Mounting the Camera
Surface Mount
1.
Pre-drill the mounting holes using the
supplied mounting template as a guide.
2.
Attach the base skirt to the mounting surface
using the supplied mounting screws and
anchors.
Note
For added support, you can attach the base
skirt to a 2S junction box.
3.
Re-attach the main camera assembly to the
base skirt. Twist the gimbal base counterclockwise to lock it in place.
4.
Adjust the gimbal position, field of view, and focus as desired
(see
Flush Mount
1.
Cut a hole in the mounting surface using the supplied mounting template as a guide.
2.
Insert the main camera assembly through the hole.
•
HD3UH(X) minidome camera
•
2nd video cable
•
DC power jack flying lead
•
Hardware kit consisting of four (4)
mounting screws and anchors
•
Mounting template
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION:
DO NOT OPEN
RISK OF ELECTRIC SHOCK
Video Cable
Power Cable
24 V AC
Base Skirt
Mounting Screws
Power Board
Camera Control Board
Gimbal
Lens
Dome Cover
Gimbal Base
Main Camera Assembly
1
Locked
Unlocked
24 V AC
CCTV Monitor
Unlocked
Locked
