2 | HD30HD1(X) Camera Quick Installation Guide
Document 800-19473 – Rev A – 12/2014
© 2014 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell. The information in this publication is believed to be accurate in all respects. However,
Honeywell cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
+1 800 323 4576 (North America only)
https://www.honeywellsystems.com/ss/techsupp/index.html
+1 44 (0) 1928 754 028 (Europe only)
4.
Rotate the middle ring and camera body to set the camera position.
5.
Tighten the base ring to lock the camera position, and then tighten the two set screws.
Regulatory Statements
FCC Compliance
Information to the User
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Note
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Canadian Compliance
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.
Manufacturer’s Declaration of Conformance
North America
The equipment supplied with this guide conforms to UL 60950-1 and CSA C22.2 No. 60950-1.
Europe
The manufacturer declares that the equipment supplied is compliant with the European Parliament and Council
Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (2011/65/EU)
and the essential requirements of the EMC directive (2004/108/EC), conforming to the requirements of standards EN 55022
for emissions, EN 50130-4 for immunity, and EN 60950-1 for electrical equipment safety.
This is a Class B product. In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
WEEE (Waste Electrical and Electronic Equipment)
. Correct disposal of this product (applicable in the
European Union and other European countries with separate collection systems). This product should be
disposed of, at the end of its useful life, as per applicable local laws, regulations, and procedures
