Rev
1.01
14
Document
900.0418
10/06
Solutions
Frequently Asked Questions
The image appears to have a white cast and looks soft.
How can I reduce this effect?
Select the Wide Dynamic Preset that gives you the best picture
for your scene. If you still have the problem, go to the
CUSTOM menu and reduce the dynamic range slider to a
lower value. Using the VIEWING menu, set the Resolution to
High and Sharpness to Normal or to Sharp.
The image on a standard high resolution color camera
appears to have brighter colors. How do I make the
HCU484 have a similar look to a traditional CCTV camera?
Select the Wide Dynamic Preset that gives you the best picture
for your scene. If you still have the problem, go to the
VIEWING menu and increase the color saturation to a higher
value.
If this
happens …
It could be
caused by …
Try this …
No picture on
monitor
Lens cap still
in place
Remove lens cap.
No power to
camera
Check that the power LED on
the camera is lit. If not lit,
check the camera power
supply.
Monitor not
functioning
Connect a test monitor to the
VIDEO Out connection and
check for a local video signal.
A faulty
coaxial cable
Check cable.
Poor picture
quality
Dirty camera
lens
Clean camera lens.
Monitor not
configured
properly
Check the monitor settings.
Ensure termination at
monitor is correct.
Check cable connections.
Camera not
focused
Set the lens focus. Refer to
the instructions that came
with your lens.
For service
and support
Refer servicing to qualified personnel or
contact Honeywell Technical Support at
+1.800.796.CCTV for assistance.
