3 - 11
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below, then set the delay (from 0-30,000 milliseconds)
by scanning digits from the inside back cover, then scanning
Save
.
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the
Lights On
bar code, below. However, if you want to turn
just the lights off, scan the
Lights Off
bar code.
Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the picture is taken. Use these codes to set the
time between when the trigger is pulled and when the picture is taken. During the delay time, the aiming light will appear, but
the LEDs won’t turn on until the delay time is over.
Default = Off.
Long (1000 ms)
Extra Long (2000 ms)
User-Specified Reread Delay
* Lights On
Lights Off
200 milliseconds
400 milliseconds
* Off
(no delay)
Содержание Genesis 7580G
