DeltaNet R7515A/B,
RP7515A/B, R7516B
MicroCel
™
Controllers
INSTALLATION INSTRUCTIONS
Warning: This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance
with the Instructions Manual, may cause interference with radio communication. It has been tested and found to comply with
the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide
reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in
a residential area is likely to cause interference, in which case, user at their own expense will be required to take whatever
measures may be required to correct the interference. Any unauthorized modification of this equipment may result in the
revocation of the owner's authority to continue its operation.
BEFORE INSTALLATION
�
The DeltaNet MicroCel Controller (“MicroCel”), shown
in Figure 1, is available in five models:
— R7515A MicroCel
— RP7515B MicroCel with Microbridge Airflow
— R7515B MicroCel with Microbridge Airflow Sensor
Sensor and Electric-Pneumatic Transducer
— RP7515A MicroCel with Electric-Pneumatic
— R7516B MicroCel with Microbridge Airflow
Transducer
Sensor and Integral Damper Actuator
AUXILIARY C-NAP
SCREW TERMINALS J7
INPUT SIDE
BASEBOARD
TERMINALS
TERMINAL LABEL
INPUTS
OUTPUTS
24V AC AUXILIARY
SCREW TERMINALS J12
INPUT BOARD
INPUTS
OUTPUTS
WALL MOD
CONNECTOR J8
GROUND
SCREW
OUTPUT SIDE
BASEBOARD
24V AC/C-NAP MODULAR
CONNECTOR J9
24V AC
AUXILIARY SCREW
TERMINALS J11
10 PIN CONNECTOR FOR
ADDITIONAL MODULE, J14
2
1
BRACKET
MOUNTING
TRIAC OUTPUT
SCREW
TERMINALS J6
CASE
OUTPUT
BOARD
1
1
1
1
2
A. INPUT BOARD SIDE
B. OUTPUT BOARD SIDE
SCREW (2)
THESE SCREWS MUST BE TIGHTLY INSERTED TO PROVIDE A GOOD GROUND FOR THE BOARDS.
USE THIS SCREW TO GROUND THE MicroCel.
C4359-3
Fig. 1. MicroCel Internal View.
Copyright © 1993 Honeywell Inc. • All Rights Reserved
95-6083
