USE & OPERATION (CONTINUED)
3
CLEANING & DRAINING THE WATER TANK
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket.
Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used for a
long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the
separate Safety & Maintenance Guide.
FILLING WITH WATER (CONTINUED)
The Water Level Indicator is located at the front of the unit. Refill the
water tank when water level is low. To avoid water spillage and water
droplets at the louvers, do not fill water above the “MAX” indicator level.
Check the water level in the tank before running the COOL function.
Make sure that the water in the tank is above the minimum water level
mark. Running the unit in COOL mode with inadequate water may
cause pump failure.
POWER
SPEED
COOL
SWING
Water Fill Door
Move the unit to a location where the water can be drained. Remove the cap from the Drain plug
located at the bottom of the unit. Allow the tank to empty.
Refill the water tank with clean water and drain it completely.
Refill the water tank with clean water, up to the maximum level.
Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
When the product is not in use, store the unit in a dry place our of direct sunlight.
t
t
t
t
t
CLEANING THE HONEYCOMB COOLING MEDIA
The appliance is supplied with a Honeycomb Cooling Media.
The Honeycomb Cooling Media is located inside the Rear
Grill. See Figure 1 for instructions on how to remove them
from the unit for cleaning and maintenance.
Do not run the unit in COOL mode with stale water in the
tank. You must empty the water tank and refill with fresh
water, especially if the tank has not been cleaned in a long
time.
The cleaning frequency for the Honeycomb media depends
on local air and water conditions. In areas where the mineral
content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the
water tank and refilling with fresh water at least once a week
will help reduce mineral deposits. If mineral deposits remain
on the Honeycomb Cooling Media, the media should be
removed and washed under fresh water. The media should
be cleaned every two months or sooner, depending on your
needs.
For best results allow the Honeycomb Cooling Media to dry
after each use by turning off the cool function 15 minutes
before turning the unit off.
t
t
t
t
t
Honeycomb
Cooling Media
Rear Grill
Figure 1:
Remove all the screws from the Rear Grill of the Air
Cooler.
Remove all the screws from the Honeycomb Frame.
Carefully slide out the Honeycomb Frame from the cooler.
The Honeycomb Cooling Media is secured on the
Honeycomb Frame by a bottom Horizontal Bar that is
fixed in place by two screws. Remove these two screws
to release the bottom Horizontal Bar and slide the
Honeycomb out of the frame.
Replace or clean media with water and a damp cloth as
needed.
WARNING:
DO NOT operate the Air Cooler when the
Rear Grill is removed from the Air Cooler, or if there is a
loose-fitting Rear Grill. Doing so can cause serious injury
or dangerous electrical shock.
1.
2.
3.
4.
5.
Removing the Honeycomb Cooling Media:
Honeycomb
Frame
Horizontal Bar