Honeywell ControlEdge 900 platform, Руководство по планированию и установке оборудования, Страница: 100 / 230

l
Channel Density: 32 Channels
l
Input voltage range: 10.5 V DC to 32V DC.
l
Isolation: Galvanic ally isolated in 2 groups of 16 channel to rack
l
Overload Current Protection: Active Current Limiting is integrated
into the output driver as 4 groups of 8 channels each. Power
cycling is not required to reset the module after a fault condition.
l
Short Circuit: Whole group of 8 output channels will be switched
off if short circuit happens in any channel of the group. Power
cycling is not required to reset the module.
l
Maximum Load Current:
o
0.5 A per channel;
o
6 A maximum per channel group ;
o
12 A maximum per module;
o
Resistive load 0.25 A per point incandescent lamp load (5 mH
maximum)
o
OFF to ON Response Time*: 6 ms
o
ON to OFF Response Time*: 6 ms
o
Power Supply Loading: 5 V: 235 mA max and 24V: 0 mA
o
20 pin EURO style terminal block
o
RTP support, 2 RTP are needed for each module. For more
information, see Using Dual RTPs to field wiring the 32 Point DC
DO section.
TIP:
*Excluding controllers scan time and excluding
transmission time from module to rack.
Terminal block styles
The terminal block is available in the barrier style, shown below at left
below, and the Euro style, shown at right. Not shown: a Euro style with
36 connections is also available for certain high capacity modules.
Figure 5-18: Terminal block Euro styles
100