31-XXXX-XX
24
Prelim Draft - Brand Neutral
BACnet IP/MSTP VAV Controller - INSTALLATION
INSTRUCTION
IMPORTANT:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
REGULATORY INFORMATION
FCC Regulation
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
Canadian Regulatory Statement
This device complies with Industry Canada license- exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le present appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisee aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible
d'en compromettre le fonctionnement.
EMF Statement
: To maintain compliance with the RF exposure
requirement, a separation distance of 20 cm between the
device and the human should be maintained.
Déclaration d'exposition Attention: Cet émetteur doit être
installé pour fournir une distance de separation d'au moins
20 cm de toute personne.
Professional Installation Warning
•
This device must be professionally installed, this should be noted
on grantee.
•
To maintain compliance, only the antenna types that have
been tested shall be used, which listed in
•
This device requires a significant technology engineering
expertise towards understanding of the tools and relevant
technology, not readily available to average consumer. Only a
person professionally trained in the technology is competent.
This device is not directly marketed or sold to general public.
Detachable Antennae Warning (IC)
Transmitter Antenna (From Section 6.8 RSS-GEN, Issue 5,
April 2018):
—
This radio transmitter 24552-00005 has been approved by
Innovation, Science and Economic Development Canada to
operate with the antenna types listed below, with the
maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly
prohibited for use with this device.
— Le présent émetteur radio [24552-00005] a été approuvé
par Innovation, Sciences et Développement économique
Canada pour fonctionner avec les types d'antenne énumérés
cidessous et ayant un gain admissible maximal. Les types
d'antenne non inclus dans cette liste, et dont le gain est
supérieur au gain maximal indiqué pour tout type figurant sur
la liste, sont trictement interdits pour l'exploitation de
l'émetteur.
