Honeywell BW GasAlertMicro, Руководство пользователя

Страница: 25 / 83

GasAlertMicro
Deactivating the Detector
The card is not required for operation; however, a warning
message displays during activation as a reminder that the
card is not inserted.
- Error - initially displays and no dAtA cArd installed then
scrolls across the screen. After the message displays, the
detector returns to normal operating mode. Insert the MMC
card if required.
Deactivating the Detector
To deactivate the detector, complete the following:
Press
A
and hold until OFF displays (approximately 5
seconds).
The audible alarm beeps four times, the visual alarm flashes
four times, and the detector vibrates.
Note
If
A
is not held down until OFF displays, the
detector will remain activated.
Confidence Beep
The confidence beep is used to confirm that the detector is
activated and the batteries have sufficient power to respond
to a hazardous level of gas.
When battery power is sufficient, the audible alarm beeps
twice every 15 seconds. The confidence beep stops when
battery power is too low.
The confidence beep can be enabled or disabled. To
enable/disable the confidence beep, complete the following:
Before activating the detector, press and hold
C
. While
holding
C
, press
A
.
As the start-up process begins, the confidence beep current
mode changes.
Note
The LCD does not display confirmation to indicate
the current mode of the confidence beep.
The normal activating/deactivating process does not
automatically enable/disable the confidence beep. It remains
in the selected mode until it is changed.
15