8300-089
26
Rev 3
Figure 5.3.5a
5.3.6.
Vertical Microactivity
Selectable from
0
to
31
. This setting is used to reduce the effects
of lost motion in the system. Cable operated systems will need to use
a higher value. Most pushrod control systems can use a value of 0.
Obtain factory assistance before making large adjustments to this
setting. The vertical axis PMICRO ACT setup screen is shown in
Figure 5.3.6a.
Figure 5.3.6a
5.3.7.
Half Step
Selectable between
0
and
1
. This setting is used to tune out an
almost imperceptible pitch oscillation where one step of the servo is
too much adjustment. Set to
1
to enable. The HALF STEP setup
screen is shown in Figure 5.3.7a.
Содержание BENDIXKing xCruze 110
