Honeywell AS302P, Руководство по эксплуатации

Страница: 9 / 92

Operating & Maintenance Instructions
5
__________________________________________________________________________
©
Honeywell - M450 001 1D - 23.05.2019
1. FOREWORD
HEALTH AND SAFETY
Compliance with Instructions in this Manual
The instructions and information in this manual are provided in compliance with Section 6 of the UK Health and
Safety at Work Act, as amended by Schedule 3 of the Consumer Protection Act 1987.
The purchaser is responsible for making sure that everyone, whether in his employment or not, who will be
associated with the products supplied by Honeywell, and to which these instructions and information apply, are
made familiar with the contents of this manual.
This applies to all persons who may be involved in activities such as unpacking, inspecting, testing, setting,
cleaning, installing, commissioning, operating, maintaining, decommissioning or disposing of the products.
Safety of Persons using Electrical Products
Employers have a duty to ensure, as far as is reasonably practicable, the Health, Safety and Welfare at Work of all
their employees. Employers must therefore ensure that employees are informed, trained and supervised and use
proper working procedures to ensure the safety of themselves and others.
The information provided in this manual is intended to ensure that products are properly installed and otherwise
handled in order to maintain them in a safe condition.
In countries outside the UK, Employers should ensure proper compliance with the Health and Safety Legislation
that is applicable to them.
Putting into Service
Products supplied by Honeywell have been designed and manufactured, in accordance with appropriate standards,
to operate under specified conditions, when properly installed.
The purchaser or delegated contractor is responsible for the "Putting into Service" of any Honeywell products that
have been supplied as "Non-connected".
All related activities must therefore be carried out with due regard to any applicable legislation, standards and good
practice.
2. WARNINGS
Internal Electronic Circuits
Parts of the internal electronic circuits of these meters are, due to technical necessity, connected to PHASE VOLTAGES.