ADEMCO 5805-6
Wireless Key Transmitter
USER GUIDE
GENERAL INFORMATION
The 5805-6 is a compact, 6-button portable
wireless transmitter that permits an alarm
system to be controlled remotely. The transmitter
is typically used for arming, disarming, panic and
output relay operation. Check with your installer
for operation of the buttons on your unit.
OPERATING THE BUTTONS
To activate a programmed function, press and
hold the associated button(s) down. The LED will
flash green to indicate the unit has transmitted
in Standard mode, or red to indicate it has
transmitted in High-Security mode.
In order to minimize the possibility of
accidental transmissions, the buttons on the
5805-6 must be pressed and held for at least
1/2 second to activate the transmitter.
Figure 1 - 5805-6 Transmitter
Table 1 - Transmitter Functions
(Complete this table with your installer)
Button
Function
ON
OFF
1
2
3
4
ON + 4
3 + 4
LOW BATTERY INDICATION
When a Button is pressed and a Low Battery
condition exists, a message is transmitted to the
control panel and LOW BAT will be displayed on
the keypad. The LED will not flash during
transmission if the battery is low.
REPLACING THE BATTERY
Removing the battery
1. Remove the case back by using the blade of a
small screwdriver to pry it open.
2. Insert the blade of a small screwdriver as
shown in Figure 2.
3. Twist the screwdriver to release the battery.
4. Carefully remove the battery.
5805-010-V0
BA
TTER
Y
(+)
INSERT
SCREWDRIVER
BLADE HERE
Figure 2 – Removing the Battery
!
Do not remove the printed circuit board.
(Continued on reverse)
