Honeywell A700, Справочник по аппаратуре, Страница: 68 / 334

Registry Key
Default
Value
A730 A730x Description
Interleaved2of5ReadingTolerance 0x0
ü
X
Tolerance for reading "hard to read"
bar codes, where
0 = high,
1 = medium, and
2 = low.
Interleaved2of5BarCodeLengthL1 0x6
ü ü
Length value L1. Range is 0x0 to 0xFF
(0 to 255).
Interleaved2of5BarCodeLengthL2 0x0
ü ü
Length value L2. Range is 0x0 to 0xFF
(0 to 255).
Interleaved2of5BarCodeLengthL3 0x0
ü ü
Length value L3. Range is 0x0 to 0xFF
(0 to 255).
Interleaved2of5BarCodeLengthMode 0x0
ü ü
Length verification mode, where
0 = "L1 is min length",
1 = "L1, L2, L3 are fixed lengths" – Not
supported on A730x,
2 = "L1 is min, L2 is max length".
Interleaved
2of5CheckDigitTransmission
0x0
ü ü
Enable transmission of the check digit.
Interleaved2of5UDSI B2
ü ü
User-defined symbology identifier.
Range is 0-4 characters.
Matrix 2 of 5
Support for the parameters in the table is labeled as follows:
ü = Parameter is supported and available via the Scanner Options tab in the device profile.
X = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters should be considered unsupported, though
they can (with knowledge) be set via the CCI or advanced settings.
IMPORTANT
A730 and A730x support for symbologies and parameters may differ. Refer to the table
below for details.
The registry keys in the table below are located under:
[HKEY_LOCAL_MACHINE\Software\Vocollect\Imager\Matrix 2 of 5]
Registry Key
Default
Value
A730 A730x Description
Matrix2of5Activation 0x0
ü ü
Enables the MSI Code symbology.
Voice Device and Headset Hardware Reference Guide 46