Honeywell 60 Series, Руководство по настройке

Страница: 41 / 93

Configuring Camera Settings
27
Note
•
The Gamma curve function is disabled when the WDR
feature in Exposure settings is enabled.
•
The brightness setting from 0% to 100% doesn't have
obvious change due to the limitation of Sony senor.
Defog
Check to improve the visibility quality of captured image in poor weather conditions such as
smog, fog, or smoke.
3D Noise Reduction
Drag the slider to adjust the reduction strength (from low to high).
Note
3D Noise Reduction is mostly applied in low-light conditions. In a
low-light condition with fast moving objects, trails of after-images
may occur. You may then select a lower strength level.
Note
All changes made to image settings are directly shown on screen.
To recall the original settings without incorporating the changes,
click
RESTORE . After you completed the settings, click SAVE .
Configuring Exposure Settings
Go to Setup

Camera Setup

Exposure .
On this page, you can set the Exposure measurement window, Exposure level, Exposure
mode, Exposure time, Gain control, and Day/Night mode settings.
Two sets of exposure settings are available:
•
In
Normal Light Mode
tab, configure normal situations for image settings.
•
In Profile Mode tab, configure special situations for image settings.
•
Night Mode: Check Enable to apply these settings at and select this mode to apply
the settings at night.
•
Schedule Mode: Check Enable to apply these settings at and select this mode to
apply the settings at a specific period. Enter the time manually in the field.