Honeywell 60 Series, Руководство по настройке

Страница: 22 / 93

Honeywell 60 Series IP Camera Software Configuration Guide
8
Configure IP Address Setting
• To obtain IP address, subnet mask, and default gateway settings automatically, select the
check box of
DHCP .
•
To configure IP address, subnet mask, and default gateway settings manually, select the
check box of
Manual and enter the settings. If you enter the start IP address, the system
can calculate the end IP address automatically according to the number of your selected
device(s).
•
After all settings are completed, click APPLY .
Configure DNS Server Address
•
To obtain the DNS server address automatically, select the check box of Obtain
automatically .
•
To manually enter the DNS server address, select the check box of Manual assignment
and enter the settings.
•
After all settings are completed, click APPLY .
Upgrading the Camera’s Firmware
Before you begin using your camera, make sure you have the latest firmware installed. You
can upgrade a single camera or multiple cameras at the same time.
Select the
Maintenance tab from the left pane as shown in Figure 2-6 , select target device(s)
and click and the following window is displayed:
Figure 2-8 Firmware Upgrade
The devices were grouped by model. To upgrade the firmware:
1. Select the target device(s) under a model.
2. Click BROWSE and select the upgrade file from your computer.