K14379V3 7/11 Rev. A
5
5
5
5870API
870API
870API
870API
Wireless Indoor Asset Protection Device
Wireless Indoor Asset Protection Device
Wireless Indoor Asset Protection Device
Wireless Indoor Asset Protection Device
INSTALLATION AND SETUP GUIDE
QUICK INSTALLATION
Peel here
Step 1. Select Location
Step 2. Select Operating Mode (refer to table 1)
Step 5.
Test System
Step 3. Program Device (refer to Programming Section)
1-3 Seconds
30
O
Painting
Jewelry Box
LOOP 3
LOOP 3
LOOP 3
LOOP 2
LOOP 1
4. Press down firmly for 5 sec.
3. Rotate into position
Step 4. Install Device
Paintings
Computers
Gun Case/Safe
Large Screen
TV
2. Enter Zone Number, Zone Type,
Input Type at Keypad
Enroll Serial Number
(press tamper switch)
Enter Loop Number at Keypad
(use Loop 2 unless Fast Trigger
or Tilt is required)
30
O
MOUNT HORIZONTALLY ONLY (LOOP 3 ONLY)
NORMAL
FAULT
30
O
OR
Jewelry
Box
Avoid sources of vibration (i.e. speakers,
fans, motors)
Choose a stable, clean, flat surface
Mount in an inconspicuous area.
2. Peel tape backing before
installing. Place onto asset.
High Security (Fast Trigger) Mode (Loop 1)
Standard Security Mode (Loop 2)
Tilt Mode (Loop 3)
5-8 Seconds
Large Screen
TV
(Asset)
Mounting
Surface
PULL TO CONNECT BATTERY
Pull tab
TAB
SENSOR
Greater than 30
O
1. Clean mounting surface
(refer to mounting notes)
Valuables
LOOP 1 is for High Security (Fast Trigger) applications and should ONLY be used if the asset will NOT
be subject to external vibration. Loop 2 (Standard Security mode) should be used in most cases.
1. Pull tab to activate battery