5816OD Wireless Outdoor Sensor – Quick Installation Guide
For Online Support visit: http://www.security.honeywell.com/hsc/resources/MyWebTech/
General Information and Component Identification
The Honeywell 5816OD Wireless Outdoor Sensor (referred
to as the sensor) brings the convenience of wireless
technology to the outdoors. The major features are:
Weatherized security protection for an outdoor
environment. Great for sheds, barns, garages, pool
gates, fences, and rural mailbox (notifications).
Versatile mounting options on flat and round materials.
Cover and rear tamper detection.
Can be painted to coordinate with mounting surface.
Operating temp: – 40 to + 50
°
C (– 40 to +122
°
F) at
RH of 100% (rain, snow).
Magnet Gap (Wood): 2 inches
Magnet Gap (Metal): 1.75 inches /no Magnet Spacer
Magnet Gap (Metal): 2 inches /with Magnet Spacer
COMPONENT IDENTIFICATION
5816OD-001-V0
SENSOR
MOUNTING
PLATE
MAGNET
MAGNET
SPACER
SENSOR
BATTERY
CHAMBER
COVER
Installing / Replacing the Batteries
IMPORTANT:
Change both batteries at the same time. Do not mix
weak batteries with new batteries.
Use two (2) lithium 1.5VDC AA cells. (For best life, use
Eveready's
Energizer Ultimate LITHIUM
AA batteries,
Honeywell part number 462)
OBSERVE BATTERY POLARITY
.
Battery Replacement:
1. Remove cover screw and swing Sensor to remove from
Sensor Mounting Plate.
2. Use screwdriver in any pivot point and pry Battery
Chamber Cover off. Replace batteries.
3. Orient Battery Chamber Cover so the screw hole lines
up with the screw hole in the sensor cover, and press to
close.
4. Engage Sensor tabs into mating holes in Sensor
Mounting Plate and swing closed. Secure with cover
screw.
5816OD-002-V0
+
+
PRY
POINTS
TERMINAL BLOCK
FOR EXTERNAL
CONTACT SWITCH
Mounting Guidelines
Mount the Magnet on the magnet sensing side of the
Sensor as indicated by the ribs on the Sensor.
Mount Sensor on
stationary
surface, and Magnet on
moveable
surface.
When used on wooden sheds and barns, mount the
sensor and magnet on the inside of the structure.
Use the Magnet Spacer when mounting on
metal
surfaces; or if needed to achieve proper alignment with
Sensor.
Flat Surfaces:
Use screws suitable for the material being fastened to.
FLAT SURFACES
COVER
SCREW
MOUNTING
SCREW (4)
5816OD-003-V0
MAGNET
MAGNET
SPACER
MOUNTING
SCREW (2)
SENSOR
SENSOR
MOUNTING
PLATE
FENCE
POST
FENCE
GATE