Honeywell 5010, Руководство пользователя

Страница: 126 / 199

8 - 2
G - Gain: This modifier boosts the signal and multiplies the pixel value. The
range is 1-8.
1G No gain (default)
2G Medium gain
4G Heavy gain
8G Maximum gain
D - Delta for Acceptance: This sets the allowable range for the white value
setting (see W - Target White Value). Delta is only available when using Photo
Style.
(Default = 25)
nD
Range: 0 - 255
L - LED State: Determines if the LEDs should be on or off, and when.
Ambient illumination (0L) is preferred for taking pictures of color documents,
such as ID cards, especially when the imager is in a stand. LED illumination
(1L) is preferred when the imager is handheld. LED State is not available
when using Decoding Style.
0L LEDs off (default)
1L LEDs on
T - Wait for Trigger: Waits for a hardware trigger pull before taking the image.
0T Takes image immediately (default)
1T Waits for a trigger pull, then takes the image
U - Update Tries: The maximum number of frames the imager should take to
reach the Delta for Acceptance. Update Tries is only available when using
Photo Style.
(Default = 6)
nU
Range: 0 - 10
W - Target White Value: Sets the target for the median grayscale value in
the captured image. For capturing close-up images of high contrast
documents, a lower setting, such as 75, is recommended. Higher settings
result in longer exposure times and brighter images, but if the setting is too
high, the image may be overexposed. Target White Value is only available
when using Photo Style.
(Default = 125)
nW Range: 0 - 255
% - Target Set Point Percentage: Sets the target point for the light and dark
values in the captured image. 1 indicates that more pixels at the light end of
a range should be used, and 99 indicates that more pixels at the dark end
should be used. We do not recommend altering this setting from the default.
To alter grayscale values, Target White Value should be used.
(Default = 50)
n% Range: 1 - 99
Image Ship - IMGSHP
An image is taken whenever the Image Snap (IMGSNP) command is processed.
The last image is always stored in memory. You may “ship” the image by using
the IMGSHP command.