Honda SH300I 2006, Руководство пользователя

Страница: 321 / 511

FRONT WHEEL/SUSPENSION/STEERING
15-7
WHEEL
Check the rim runout by placing the wheel in a tru-
ing stand.
Spin the wheel slowly and read the runout using a
dial indicator.
Actual runout is 1/2 the total indicator reading.
WHEEL BEARING
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the hub.
Remove and discard the bearings if the races do not
turn smoothly, quietly, or if they fit loosely in the
hub.
Carefully check bal-
ance before install-
ing the wheel.
WHEEL BALANCE
• Mount the tire with the arrow mark facing in the
direction of rotation.
• For optimum balance, the tire balance mark (light
mass point: a paint dot on the side wall) must be
located next to the valve stem. Remount the tire
if necessary.
• The wheel balance must be checked when the
tire is remounted.
Mount the wheel, tire and brake disc assembly on
an inspection stand.
Spin the wheel, allow it to stop, and mark the lowest
(heaviest) part of the wheel with chalk.
Do this two or three times to verify the heaviest
area.
If the wheel is balanced, it will not stop consistently
in the same position.
SERVICE LIMITS:
Radial: 2.0 mm (0.08 in)
Axial:
2.0 mm (0.08 in)
Replace the wheel
bearings in pairs.
VALVE STEM
BALANCE MARK
ARROW
INSPECTION
STAND