Honda NC700 2012, Руководство по обслуживанию

Страница: 729 / 773

22-6
dummyhead dummyhead
LIGHTS/METERS/SWITCHES
TURN SIGNAL LIGHT
BULB REPLACEMENT
Remove the screws [1] and turn signal light lens [2].
While pushing in the bulb [3], turn it counterclockwise to
remove it.
Replace the bulb with a new one.
Check the packing [4] is installed in position and is in
good condition, replace it with a new one if necessary.
Install the turn signal light lens and screw.
Tighten the screw securely.
REMOVAL/INSTALLATION
FRONT (NC700X/XA/XD)
Remove the front side cowl (page 2-24).
Remove the turn signal light mounting screw [1], setting
plate [2] and turn signal light [3].
Remove the mounting rubber [4].
Installation is in the reverse order of removal.
Route the wires properly (page 1-25).
FRONT (NC700S/SA/SD)
Remove the headlight/headlight stay (page 2-27).
Disconnect the front turn signal light 3P connector [1].
Remove the turn signal light mounting screw [2], setting
plate [3] and turn signal light [4].
Remove the mounting rubber [5].
Installation is in the reverse order of removal.
Route the wires properly (page 1-25).
[2]
[3]
[1] [4]
TORQUE:
Turn signal light mounting screw:
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
[1]
[3]
[2] [4]
TORQUE:
Turn signal light mounting screw:
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
[2]
[4]
[3]
[5]
[1]