Honda NC700 2012, Руководство по обслуживанию

Страница: 552 / 773

16-9
dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
The jack height
must be continually
adjusted to relieve
stress for ease of
bolt removal.
Support the engine using a jack or other adjustable
support to ease of engine hanger bolts removal.
Remove the upper engine hunger bolts [1] and collar
[2].
Remove the front lower hunger bolts [1] and collars [2].
Remove the rear engine hunger nuts [1], collars [2] and
bolts [3].
Carefully maneuver the engine and remove it out of the
frame to the right.
During engine removal, hold the engine securely and
be careful not to damage the frame and engine.
ENGINE REMOVAL (NC700XD/SD)
Drain the engine oil (page 3-13).
Drain the coolant (page 8-6).
Fully slacken the drive chain (page 3-17).
Relieve the fuel pressure and disconnect the quick
connect fitting from the fuel injector side (page 7-4).
Remove the following:
– Left rear cover (page 2-30)
– Guard pipe (page 2-30)
– Center cross plate (page 2-32)
– Exhaust pipe/muffler (page 2-32)
– Radiator (page 8-9)
– Radiator reserve tank (page 8-14)
– Throttle body (page 7-15)
Disconnect the CKP sensor 2P (Red) connector [1] and
release the CKP sensor harness.
Left side: [2] Right side:
[1] [1]
[2] [1] [1] [2]
Left side: Right side:
Left side: Right side:
[2]
[3] [1]
[1]
[3]
[2]
[2]
[1]