Honda NC700 2012, Руководство по обслуживанию

Страница: 462 / 773

12-107
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Apply engine oil to the needle bearings in the primary
driven gear.
The primary driven gear has the index line [1] on its
flange for the installation direction. The dual clutch
assembly should be installed with the index line facing
the outside.
Line up the clutch disc tabs with the two wide grooves
[2] aligned as shown.
Install the washer [3] onto the clutch assembly.
Install clutch guide 1 [4] into the clutch on the index line
side by aligning the gear teeth with the clutch disc tabs.
Turn over the dual clutch assembly while holding clutch
guide 1.
Apply engine oil to the needle bearings in the primary
driven gear.
Line up the clutch disc tabs with the two wide grooves
[1] aligned as shown.
Install the washer [2] onto the clutch assembly.
Install clutch guide 2 [3] into the clutch by aligning the
gear teeth with the clutch disc tabs.
INSTALLATION
Apply engine oil to new seal rings [1] and install them
into the mainshaft grooves.
Push in the seal rings to seat them into the grooves.
Install the dual clutch assembly [1] onto the mainshaft,
being careful not to damage the seal rings.
Install the ball bearing [2] onto clutch guide 1 with the
marked side facing out.
[3]
[4] [1] [2]
[3]
[2]
[1]
[1]
[1]
[2]