Honda NC700 2012, Руководство по обслуживанию

Страница: 282 / 773

8-3
dummyhead dummyhead
COOLING SYSTEM
SERVICE INFORMATION
GENERAL
Using coolant with silicate inhibitors may cause premature wear of water pump seals or blockage of radiator passages. Using tap
water may cause engine damage.
• Add coolant at the reserve tank. Do not remove the radiator cap except to refill or drain the system.
• All cooling system services can be done with the engine installed in the frame.
• Avoid spilling coolant on painted surfaces.
• After servicing the system, check for leaks with a cooling system tester.
• Refer to the ECT sensor inspection (page 22-18).
SPECIFICATIONS
TORQUE VALUES
Removing the radiator cap while the engine is hot can allow the coolant to spray out, seriously scalding you.
Always let the engine and radiator cool down before removing the radiator cap.
ITEM SPECIFICATIONS
Coolant capacity Radiator and engine 1.69 liters (1.79 US qt, 1.49 Imp qt)
At draining 1.41 liters (1.49 US qt, 1.24 Imp qt)
Reserve tank 0.13 liter (0.14 US qt, 0.11 Imp qt)
Radiator cap relief pressure 108 – 137 kPa (1.1 – 1.4 kgf/cm
2
, 16 – 20 psi)
Thermostat Begin to open 80 – 84°C (176 – 183°F)
Fully open 95°C (203°F)
Valve lift 8 mm (0.3 in) minimum
Recommended antifreeze High quality ethylene glycol antifreeze containing silicate-free
corrosion inhibitors
Standard coolant concentration 1:1 (mixture with distilled water)
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Water hose band screw 6 – – See page 8-9
See page 8-10
See page 8-14
Fan motor shroud mounting bolt 3 6 8.4 (0.9, 6.2)
Fan motor mounting screw 3 4 2.7 (0.3, 2.0)
Cooling fan mounting nut 1 3 1.0 (0.1, 0.7) Apply locking agent to the threads.