13-19
4. ASSEMBLY
a. PISTON ASSEMBLY
1) Install the piston pin clip only on one side of the piston.
Take care not to let the piston pin clip jump out of position.
NOTICE
2) Warm up the piston to approximately 70˚C (158˚F).
3) Apply molybdenum disulfide oil to the outer surface of the
piston pin, inner wall of the piston pin hole in the piston
and to the inner wall of the connecting rod small end.
Install the connecting rod on the piston and install the
piston pin.
Install the piston pin so that the “
” mark on the piston
head points to the model mark on the connecting rod.
4) Install the piston pin clip on the opposite side from where
the piston pin clip was installed in step 3.
Take care not to let the piston pin clip jump out of position.
5) Install the connecting rod bearing on the connecting rod by
aligning the projection on the bearing with the concave in
the connecting rod.
NOTICE
NOTICE
[1]
PISTON PIN
CLIP
[1]
“
” MARK
[2]
MODEL MARK
[5]
PISTON PIN
CLIP
[4]
PISTON PIN
[8]
PISTON
[7]
CONNECTING
ROD
[6]
CONNECTING
ROD BEARING
CAUTION
[3]
MOLYBDENUM
DISULFIDE OIL
Take care not to get your hand, etc. burned during
assembly.