BF135A•BF150A
5-135
f. SILENCER CASE INSTALLATION
1) Install the silencer case and tighten the three 6 x 25 mm
flange bolts and the three 6 mm washers.
• Check that the wire harnesses are not pinched.
• Set the main harness in the groove in the left lower sec-
tion of the silencer case.
2) Tighten the three 6 x 25 mm flange bolts securely.
3) Connect the crankcase breather tube.
4) Fasten the air flow tube clamp securely.
5) Connect the IAT sensor 2P connector and secure the har-
ness band clip in the hole in the silencer case.
[1] SILENCER CASE
[4] SILENCER CASE
[3] 6 mm WASHER (3)
[5] WIRE HARNESS
[2] CRANKCASE BREATHER TUBE
6 x 25 (3)
[3] IAT SENSOR 2P
CONNECTOR
[2] AIR FLOW
TUBE CLAMP
[1] HARNESS
BAND CLIP