Honda HS1336i, Руководство пользователя

Страница: 85 / 144

83
SERVICING YOUR SNOW BLOWER
ENGINE OIL LEVEL CHECK
Check the engine oil level with the engine stopped and in a level position.
1. Adjust the snowblower so that the bottom of the engine cover is horizontal
seen from the side by adjusting the auger angle.
2. Remove the oil filler cap/dipstick and wipe it clean.
3. Insert and remove the dipstick without screwing it into the filler hole. Check
the oil level shown on the dipstick.
4. If the oil level is low, fill with the recommended oil (see page 86) to the upper
limit on the oil filler cap/dipstick.
5. Reinstall the oil filler cap/dipstick.
Running the engine with a low oil level can cause engine damage. This type of
damage is not covered under the Distributor's Limited Warranty (U.S.) / Distributor's
Warranty (CA.).
ENGINE OIL FILLER CAP/DIPSTICK
ENGINE OIL FILLER CAP/DIPSTICK
UPPER LIMIT
(The oil shows at the upper end
of the dipstick hash marking.)
LOWER LIMIT
(The oil only shows at the lower
end of the dipstick.)
Adjust to be horizontal seen from the
side by adjusting the auger angle.
31V156250.book 83 ページ ２０２０年１２月２２日 火曜日 午後１時３６分