Honda HRX217HYUA, Руководство пользователя

Страница: 15 / 24

15
TROUBLESHOOTING
Engine Will Not Start
Loss of Power
Vibration
Mowing and Bagging Problems
Possible Cause Correction
Throttle lever in wrong position Move the throttle lever to the
FAST position (
page 9 ).
Fuel valve OFF Turn the fuel valve ON
(
page 3 ).
Out of fuel Refuel ( page 7 ).
Bad fuel; mower stored without
treating petrol, or refueled with bad
petrol Refuel with fresh petrol
(
page 7 ).
Spark plug faulty, fouled, or
improperly gapped Gap or replace the spark plug
(
page 13 ).
Spark plug wet with fuel (flooded
engine) Dry and reinstall the spark
plug.
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc. Take the mower to an
authorised Honda servicing
dealer for repair.
Possible Cause Correction
Throttle not set to FAST Move the throttle lever to the
FAST position (
page 8 ).
Grass is too tall Raise the cutting height
(
page 6 ), cut a narrower
swath, use a slower ground
speed, or cut more frequently.
Instead of mulching, try rear
discharging or bagging.
Mower deck is clogged Clean out the mower deck
(
page 14 ).
Air filter is clogged Clean or replace the air filter
(
page 12 ).
Bad fuel; mower stored without
treating petrol, or refueled with bad
petrol Refuel with fresh petrol
(
page 7 ).
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc. Take the mower to an
authorised Honda servicing
dealer for repair.
Possible Cause Correction
Grass and debris lodged under the
mower deck Clean out the mower deck
(
page 14 ).
Blades loose Tighten loose blade bolts
(
page 11 ).
Blades bent, damaged, or
unbalanced by improper
sharpening Take the mower to an
authorised Honda servicing
dealer for repair.
Mechanical damage, such as a
bent crankshaft
Possible Cause Correction
Mower is moving too fast for lawn
conditions Adjust the Select Drive knob
toward MIN position (
page 9 ).
Cutting height adjustment levers
set at different positions Set all levers at the same
cutting height position
(
page 6 ).
Grass bag clogged Wash the grass bag
(
page 14 ).
Mower deck is clogged Clean out the mower deck
(
page 14 ).
Blades dull, worn, or damaged Sharpen or replace the
blades if necessary
(
page 11 ).
Wrong blades installed Install correct blades
(
page 11 ).