Honda HRR216VKA K10, Руководство пользователя

Страница: 81 / 183

8-6
FUEL SYSTEM HRR216VKA
CLEANING
Use the jet cleaner set special tool (P/N 07JPZ-001010B) and Honda Carburetor Cleaner (P/N 08732-CC000) with
its plastic spray nozzle to clean the carburetor ports.
Some commercially available chemical carburetor cleaners are very caustic. These cleaners may damage plastic
parts such as O-rings, floats, choke valves, and float valve seats. Check the container for instructions. If you are in
doubt, do not use these products to clean Honda carburetors.
NOTICE
High air pressure may damage the carburetor. Use low pressure settings when cleaning passages.
BEFORE CLEANING
• If a significant amount of water, contamination, or deteriorated gasoline is inside the float chamber, inspect and
clean the inside of the fuel tank and fuel filter screen.
• Carefully inspect all the gaskets for damage and replace as necessary.
• Be sure the work surface is clean.
• Use compressed air pressure of 207 kPa (30 psi) maximum.
CLEANING PROCEDURE
1. Thoroughly clean the outside of the carburetor body using carburetor cleaner and compressed air.
Inspect the carburetor body, throttle and choke levers, and pilot screw (if equipped) (including limiter cap) for
damage. If any damage exists, carburetor replacement may be necessary.

CAUTION
Always wear a face shield or safety glasses when using carburetor
cleaner or compressed air. Applying pressure into small passages can
cause fluid and air to shoot back into your face.