Honda HRR216VKA K10, Руководство пользователя

Страница: 53 / 183

3-12
MAINTENANCE HRR216VKA
FUEL TUBE INSPECTION
1. Check the fuel tubes for deterioration, cracks, or signs of
leakage. Replace the fuel tubes if necessary.
2. To replace the fuel tubes, drain the fuel into a suitable
container.
Honda Power Equipment manufactured in 2009 and later uses
low-permeation fuel tubes that have the CARB Executive
Order (C-U-05-003, for example) printed on them.
If you replace a low-permeation fuel tube, you must replace it
with a low-permeation fuel tube that has the emissions-
compliance identification number printed on it. If you replace a
regular fuel tube, you can replace it with a regular fuel tube.
Two styles of fuel tube clamps have been used. If you replace
the clamps, use the same style that is currently on the mower.
13. FLYWHEEL BRAKE
INSPECTION
1. Remove the recoil starter ( P. 7-1 ).
2. Remove the fan cover.
3. Measure the thickness of the brake shoe.
4. If brake shoe thickness is less than the service limit, replace the
flywheel brake shoe.
K9~K11 Flywheel Brake Spring Installation
Flywheel removal is required to install a new spring ( P. 9-1 ).
Install the flywheel brake spring as shown. Make sure the hook on
the long end of the spring is attached down through the hole in the
flywheel brake arm.
Service limit 3.0 mm (0.12 in)
EMISSIONS-COMPLIANCE
IDENTIFICATION NUMBER
FUEL TUBE
FUEL VALVE
“D” STYLE CLAMP WIRE STYLE CLAMP
FLYWHEEL BRAKE SHOE
3.0 mm (0.12 in)
K9~K11
K5 thru K8